MIMAKI JV4 Series, Operation Manual

Page: 67 / 152

- 1.49 -
OTHER SETTINGS
INSTALLING THE MEDIUM SUPPORT
Install the media support to the platen so as to prevent hard media such as canvas from rising.
Put the hook of medium support in the hole of
platen.
Change the installing location and the number of media
supports to be installed according to the width of medium to
be used.
SWITCHING THE DIRECTION OF WINDING OF THE MEDIUM
The take-up device is mounted with a switch that specifies the direction in which a medium is
wound.
FORWARD : The take-up device winds the medium
with its plotting face faced out.
OFF : The take-up device will not wind the
medium.
REVERSE : The take-up device winds the medium
with its plotting face faced in.
SETTING THE TORQUE LIMITER
There is torque limiter adjustment mechanism in take-up device.
The torque limiter is in two place of the take-up device ane the roll-holder.
Strengthen the adjustment of the Torque Limiter when a roll paper is heavy and hard to keep tension.
• Clockwise : It becomes strong. • Anti-clockwise : It becomes weak.
Medium to be used : The thick media, such as Tarpourin. Medium to be used : A light medium
Torque Limiter
Switch
(50% of maximum
Torque Limiter Mark) (100% of maximum
Torque Limiter Mark)
Adjustment nut
Torque Limiter mark