MIMAKI JV4 Series, Operation Manual

Page: 64 / 152

- 1.46 -
SPECIFYING THE SCOPE OF PLOTTING ON THE MEDIUM USED
(EFFECTIVE PLOTTING AREA)
The device has an area which cannot perform printing, due to mechanical reasons. This area is called
“dead space.”
The effective printing area is obtained by excluding the dead space from the printing medium.
Note that the minimum value of dead space differs from one model to another.
<JV4-130/160>
<JV4-180>
CHANGING THE DEAD SPACE
The dead space may be changed as required.
The effective plotting area can be changed by changing the dead space.
For the method of setting a dead space, see page 3.13.
0 mm
5 mm
Medium
feeding
direction
85 mm
Roll medium
Cut sheet medium
50 mm
Effective
printing
area Effective
printing
area
5 mm 5 mm
85 mm
5 mm 5 mm 5 mm
Effective
printing
area
Board medium
5 mm
135 mm
0 mm
25 mm
Medium
feeding
direction
85 mm
Roll medium
Cut sheet medium
50 mm
Effective
printing
area Effective
printing
area
25 mm
25 mm
85 mm
25 mm
25 mm
25 mm
Effective
printing
area
Board medium
5 mm
135 mm