MIMAKI JV4 Series, Operation Manual

Page: 48 / 152

- 1.30 -
TO REPLENISH INK, SET A NEW INK CARTRIDGE IN THE INK STATION.
Ink replenishment is done by replacing the ink cartridge with a new one.
If the ink cartridge is not replaced, plotting is interrupted if the ink runs out.
If the message [INKnearEND] appears, immediately load a new ink cartridge.
1. When the amount of ink becomes small during
plotting.
The amount of ink of the color indicated is running out. Set a
new ink cartridge of K (black) in the R-row ink station.
2. When the amount of ink completely runs out
during plotting.
The amount of ink of the color indicated has completely run
out.Set a new ink cartridge of C (Cyan) in the F-row ink
station.
STEP
1. Either of the messages shown above is dis-
played on the LCD during plotting.
When [INKnearEND] appears, the local mode is entered and
the operation stopped each time plotting of a single data is
completed. Proceed with Step 2 at the end of the plotting
operation. Proceed to Step 2 at the end of the plotting
operation.
When [INKEND] appears, plotting cannot be continued.
2. Install a new ink cartridge.
Pull out the ink cartridge of the indicated color and then load
a new ink cartridge.
3. When the ink cartridge has been loaded, draw-
ing is possible again.
• When two ink sets of the same type are loaded to two ink stations, if
[INKnearEND] occurs during plotting, only one ink set is used.
Therefore, the [PRINT CONT.] function can be used which allows continuous
data plotting without interrupting the plot operation(See page 3.27).
< LOCAL > INKnearEND
K - - - - -
- - - - - -
< LOCAL > INKEND
- - - - - -
- C - - - -