MIMAKI JV3-130SPII, Operation Manual

Page: 127 / 150

- 5.35 -
5. Press the Jog key [ ] or [ ] to select the
amout of ink you want to use (in 10cc incre-
ments).
* Maximum ink amount can be used for this function is 30cc.
6. Press the [ENTER] key.
If press the [END] key, it cancel the operation and return to
the LOCAL mode.
7. Press the [ENTER] key.
The menu returns to the LOCAL mode.
If multiple ink cartridges are small amount at a
time, repeat this procedure.
ADD REMAIN
+ 0 cc + 20 cc
ADD REMAIN
Execute : ent
< LOCAL >
NEAR END - K - - - - - -
Current Value Total Value
Example of adding 20cc
Using further remaining ink in the ink cartridge
After conduct the above procedure and printing, some ink may still remain in the ink car-
tridge.
At this time it is possible to use remaining ink by selecting the amount of ink again.
• Be careful that if additional amount of remaining ink exceed the actual
remaining amount, prinitng continues even ink ended. Furthermore air enter
the ink tube which cause abonormal printting.
• It is not able to select more than 30cc. If 30cc had been already added , can
not add anymore.
At here it is explained by taking an example of adding further 10cc after added 20cc and
printed.
STEPS:
1. When the ink level becomes low, [NEAR END]
is displayed.
(When ink ends, [INK END] is displayed)
2. Remove the ink cartridge and confirm the
weight of remaining amount of ink.
*Refer to the above table
< LOCAL >
NEAR END - K - - - - - -
< LOCAL >
CARTRIDGE - K - - - - - -