MIMAKI JV3-130SPII, Operation Manual

Page: 113 / 150

- 5.21 -
Reduce printing time of narrow image [SCAN WIDTH]
This function allows you to reduce the printing time by set to OFF.
However nozzle out may occurs. Therefore it is recommended set to ON.
When it is set to ON, scan operation is performed 60cm/23.6 inch in width (selectable)
regardless of data or media width. This function is valid when using SS2 ink.
STEPS:
1. Select the [SCAN WIDTH].
page 5.2.
2. Press the [ENTER] key.
Current status is displayed.
(Initial setting is ON.)
3. Press the Jog key [ ] or [ ] to select the
[ON/OFF].
ON: Scan with input width.
(Able to select the value. Go to step7)
OFF: Scan with LOGICAL SEEK setting (Go to step9)
LOGICAL SEEK ON: Data width (Image width)
LOGICAL SEEK OFF: Media width
• Setting is OFF, nozzle out may occur and
image quality decline.
4. Press the [ENTER] key.
5. Press the Jog key [ ] or [ ] to input the width
of scan.
If nozzle out is not recovered, change the input value to
larger number.
6. Press the [ENTER] key.
7. Press the [END] key twice.
The menu returns to the LOCAL mode.
SCAN WIDTH
RENEW
: ON
SCAN WIDTH
RENEW
: OFF
MAINTENANCE
SCAN WIDTH
< ent >
SCAN WIDTH
WIDTH
: 400 mm
SCAN WIDTH
WIDTH
: 500 mm
MAINTENANCE
SCAN WIDTH < ent >
< LOCAL >
TWICE