MIMAKI GP-604D, Operation Manual

Page: 30 / 134

- 1.12 -
MENU mode
There are the following three mode in this device.
LOCAL mode
This is the mode after the initial performance.
All keys are effective to enable setups.
The device is able to receive data from computer, however, it will not perform plotting.
In this mode, it is possible to perform the following operations.
1. Pressing the [CYCLE START] keys to detect thickness of the garment.
(After detecting, revert to the LOCAL mode.)
2. Pressing the [FUNCTION] key to set plotting conditions. (=> Function mode)
3. Pressing the [TEST] key to start test plotting.
4. Pressing the [CLEANING] key to cleaning the head.
5. Pressing the [DATA CLEAR] key to erase the plotting data the device has received.
6. Pressing the [LED POINTER] key to set the print area.
7. Pressing the JOG key to set origin.
8. Pressing the Z key to adjust the height of the head.
FUNCTION mode
While the device is in the LOCAL mode, press the [FUNCTION] key to put the device into the
FUNCTION mode.
Set the each plotting condition in the FUNCTION mode.
REMOTE mode
Plots the received data.
During the plotting operation, press the [REMOTE] key to interrupt the plotting operation.