MIMAKI GP-604D, Operation Manual

Page: 108 / 134

- 6.2 -
Before taking a phenomenon as a sign of failure
Corrective measures against troubles in the case where no error message is given on the LCD are
described in this section. Make sure to take the following measures before taking the trouble as a
sign of failure. If the measures fail restore the device to the normal state, contact your local
MIMAKI distributor or MIMAKI office to call for service.
The device cannot be energized
More often than not, this is due to improper connection of the power cable. Check that the power
cable has been properly connected to the power outlet and the computer.
The device cannot perform printing
In case data is not transmitted to the device properly, the device may not perform printing. Confirm
the cable in use.
Has the power cable been con-
nected to the device and the
receptacle? Securely connect the power cable
to them.
Is the correct interface cable
used?
Has the interface cable been
securely connected in position?
Is the message telling that ink has
run out shown on the display?
Use the cable exclusive for the
device.
Securely connect the interface
cable in position.
Replace the ink cartridge with a
new one.
No
Is the main switch ON?
Turn on the power of the main
switch.
Yes
No
No
Yes
No