25
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Recognize and cut Registration Mark
(in use of CG-FX series)
FineCut enables to detect the registration mark set on the CG-FX at high speed.
Perform two cutting patterns: continuous multiple same data cutting on a roll sheet,
and continuous multiple same data cutting as exchanging a leaf sheet.
< Cut on a roll sheet continuously >
• Only one set of the registration mark data (4 marks) is available to cut con-
tinuously. In case two or more sets of the registration marked data exists in
a sheet, cannot cut continuously.
• Standardize a shape of the registration mark. In case a different shape of
the registration mark mixed, cannot detect the registration mark precisely.
• Set the register mark size to 8 mm or more. (see page 21)
• Set in array the horizontal registration marks within 5.
• Set the same size and position between the output leaf sheet size and the
print position.
1
Set a output result on a plotter to detect registration mark.
For the procedure of registration mark detection, refer to the Mimaki CG-FX series
operation manual.
Detection of registration mark
(Semi-automatic mode)
1. Enable “MARK DETECT” function on the
plotter. Set the registration mark information:
size, shape, and so on. Select “1pt” as detecting
mark number.
2. Place the sheet on the plotter turn the sheet set
lever toward you.
3. Press Jog key to detect the placed sheet.
4. Move the spot LED into the area illustrated on
the left figure.
5. Press
key.
6. Return to LOCAL mode after detecting the
registration mark.
