MIMAKI DS-1600, Operation Manual

Page: 154 / 172

- 5.8 -
Error messages
Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the plotter and turn it on after
a while.
If the same error message appears again on the LCD, contact your local MIMAKI distibutor or
MIMAKI office to call for service.
Control ROM is defective.
Control RAM is defective.
Power voltage becomes
abnormal.
Control ROM is defective.
Abnormal temperature is
detected.
Trouble with detection of
linear encoder.
Control circuit board is defective.
(FPGA Error)
Control circuit board is defective.
(HDC Error)
The plotter has received data
other than command data.
A parameter outside the range
of acceptable numeric values
is received.
Maintenance command is
abnormal.
Irregular in receiving data.
Color command is abnormal.
Turn off the power to the plotter
an turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Securely connect the interface
cable in position.
Check the output setting of the
host computer.
Turn off the power to the plotter
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Error message Cause Corrective measure
E R R O R 0 1
M A I N R O M
E R R O R 0 2
M A I N R A M
E R R O R 0 3
POW E R + 3 5 V
E R R O R 0 4
F - R O M
E R R O R 0 7
T E M P ( 0 0 0 0 )
E R R O R 0 8
L I NE A R E N C O DE R
E R R O R 0 9
F P G A
E R R O R 0 9
F D C
E R R O R 1 0
C O M M A N D
E R R O R 1 1
P A R A M E T E R
E R R O R 1 2
MA I N T E C O M M AND
E R R O R 1 3
R I P L I N K
E R R O R 1 4
CO L O R C O M M A ND