MIMAKI DS-1600, Operation Manual

Page: 115 / 172

- 4.5 -
Printing HEX code of printing command [DATA DUMP]
This function plots data commands received from the computer, in HEX code.
The HEX code is an alphanumeric representation of printing commands.
By using this code, it is possible to check if there are any abnormal data commands.
• When this function is used to output data commands on a sheet of paper, use
A4 or larger size with the long side set horizontally.
• DATA DUMP automatically feeds line according to the size of paper used.
STEPS:
1. Select [DATA DUMP] from [MAINTENANCE].
(See page 4.3)
2. Press the [ENTER] key.
Transfer data from the host computerand drawing the DATA
DUMP is started.
3. When printing is completed, press the [REMOTE]
key.
4. Press the [DATA CLEAR] key.
5. Press the [ENTER] key.
The menu enters the LOCAL mode.
DATA DAMP
M A I N T E N A N C E
D A T A D U M P < e n t >
M A I N T E N A N C E
* * D A T A
D U MP * *
< < L O C A L > >
w i d t h : 1 2 7 2m m
< < L O C A L > >
w i d t h : 1 2 7 2m m
D A T A C L E A R
< E N T >
* * D A T A
C L E AR * *