MIMAKI DM3-1810S, Operation Manual

Page: 42 / 146

- 2.8 -
Fixing the work holder
When fixing the warped-up work (at two or four arched edges) in the allowable size (1870 x 1050
mm maximum), use the work holders on the four table edges.
STEPS:
1. Turn (or remove) the knob screws to loosen the
work holder.
A collar is fitted to each of the screws of the
work holder. Do not lose them when they are
removed.
2. The right and left work holders may be turned
upside down as needed according to the work
size.
3. Place the work between the work holder and
the table.
4. While pressing the work holder down, re-
tighten the knob screws.
Right and left work holders
(square C-shape)
Front and back work holders
(L-shaped; cannot be turned
upside down)
Work holder
Knob
Turn upside down
Work
Table