MIMAKI DM2-1810, Operation Manual

Page: 47 / 146

- 2.17 -
Correcting the media feed rate during plotting
To perform this operation during LOCAL mode, refer to the “Feed Correct”( page 2.15).
The following describes the procedures to alter the media feed rate during plotting or in a REMOTE
mode.
STEPS:
1. Press the [REMOTE] key.
2. Press the [FUNCTION] key to confirm the
current setting value.
Press the [END] key when an appropriate value is set or to
abort the operation.
3. Press the [ENTER] key.
Available to alter the medium feed rate.
4. Press the XY [ ] or [ ] keys as needed to set
the amount of correction.
Setting value is available from -100 to +100. Press the [END]
key to return to the REMOTE display. The altered value
ceases to be in effect, and returns to the previous value.
• A new value takes effect in real time. The best effect can be obtained while
checking the result.
• The unit of the correction value is the same as in “Feed Correct” in the LO-
CAL mode. ( page 2.15)
• Setting value is to be Reset as follow,
*Perform the Feed Correct.
*Perform the Setup reset
5. Press the [ENTER] key.
Confirm the medium feed rate before saving it. Press the
[END] key to return to the REMOTE display. The changed
setting value is to be in effect performing till the next power
on.
6. Press the [ENTER] key to return to the RE-
MOTE display.
The changed setting value is saved. The value is to be in
effect performing till Reset.
< REMOTE > TYPE ∗
X= ∗ ∗ ∗ ∗ Y= ∗ ∗ ∗ ∗
Feed Comp. -50
Adjust : ent
Feed Comp. -50
Adjust = 100
Feed Comp. 100
Save : ent
< REMOTE > TYPE ∗
X= ∗ ∗ ∗ ∗ Y= ∗ ∗ ∗ ∗