MIMAKI CJV30-100, Operating Manual

Page: 69 / 274

2-37
2
Bas
ic Operations
Test Cutting
Test cutting is performed to check whether the settings for tool conditions are appropriate.
In test cutting, two squares shown right are cut.
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press the key.
• Test cutting is performed.
According to the result of the test cutting, configure the settings for the cutting condition again.
• When the cutter cuts badly because of the wear of the blade, the value of PRESSURE can be increased
temporarily to deal with the problem.
(This should be done only temporarily. It is recommended that the blade of the cutter be
replaced with a new one to maintain cutting quality.)
• Test cutting performs the operation at the current cutter position. (When there is not a cutter unit on the
medium, test cutting is performed at the drawing origin.)
• When cutting the data after test cutting, the origin must be moved in advance. If you cut without moving
the origin, there is a possibility of overlapping on the test cutting.
• When detecting the medium and the mode is in print mode, if you perform test cutting as it is, the
following screen will be displayed by pressing the key in Step 2. In this case, press
the key to switch the setting of pinch roller pressure to the cut mode and then perform the
test cutting.
• If the key is pressed, switching operation will not be
performed.
• When the settings for tool conditions are appropriate, the result of the test cutting is as follows:
The two squares have been cut out completely.
The backing paper has not been cut.
The corners of the squares are not round.
The corners of the squares are not turned up.
Symptom Cause Countermeasure
Some parts have not been
cut. The cutting speed is too high, the blade
edge is lifted. Reduce the speed. ( P.2-4)
Tighten the knob of the tool holder further.
(
P.2-12)
The backing paper of the
medium is cut. The cutting pressure is too high. Reduce the pressure. ( P.2-4)
The length of the blade edge drawn out
is too long. Adjust the length of the blade edge drawn out.
(
P.2-11)
The corners of the square are
round. The OFFSET value is not appropriate. Adjust the OFFSET value according to the
state of the cutter you use. (
P.2-4)
The corners of the square are
turned up. The length of the blade edge drawn out
is too long.
The cutting pressure is high.
[ADJ-PRS OFFSET] is large.
Two or more of the above apply. Adjust the length of the blade edge drawn out.
(
P.2-11)
Adjust the cutting pressure. ( P.2-4)
Adjust the ADJ-PRS OFFSETvalue.
(
P.4-33)
! PR PRESSURE : PR I NT !
SWI TCH : e n t
< LOCA L . C > [ # 0 1 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
T ES T CUT
< ENT >
* * T ES T CUT * *