Plotter Driver Setup
15
(3) Cut condition
Edit the tool, speed, pressure, and offset for each color.
The cutting sequence cannot be set here. The cutting
sequence is dependent on the application being used.
Check by actually outputting the data.
• Priority-plotter (except “Tool”):
Enabled ....... Cuts using the plotter tool
conditions.
Disabled ...... Cuts using the tool conditions
listed.
• Use No. 1 condition only:
Enabled .............Cuts all colors using the tool conditions set in No. 1 in the list.
Disabled ............Allows cutting by selecting the tool conditions for each individual color.
• Color:
If the color for which tool conditions are to be set is not listed, click [Color], and change to the
required color. The tool usage sequence cannot be set here.
• Tool:
Sets the tool used (CUT1 - CUT6, CRE, PEN) with the plotter for the selected color.
• Speed:
Sets the cutting speed (1 - 73 cm/s). Selecting “0” uses the plotter setting.
• Press
Sets the cutting pressure (1 to 550 g). Selecting “0” uses the plotter setting.
• Offset
Sets the cutting offset (0.01 - 2.50 mm). Selecting “0” uses the plotter setting.
• If [Priority-plotter (except “Tool”)] is checked, the listed settings cannot be altered.
• If [Use No. 1 condition only] is checked, the settings for [Undefined color] cannot be
altered.
• If the values set exceed the permissible setting limits for the plotter used, the
corresponding plotter limit values will be used.
