MIMAKI CG-100AR, Operation Manual

Page: 87 / 184

Chapter 3 Cutting Data with Register Marks
87
Setting Details
TP1
TP2
TP3
TP4
TP1
TP2
TP3
TP4
Register mark: Type 1 Register mark: Type 2
l
COPIES A (UP) and COPIES B (LEFT) settings [COPIES A (↑) and COPIES B (<-)]
Setting Details
1 to 9999
(COPIES A)
1 to 99
(COPIES B)
This is enabled when the same pattern is printed in multiple with uniform spacing.
The specified number of patterns is cut while continuously reading the register marks
based on the first data.
Set the number in the A direction for [COPIES A] and the number in the B direction for
[COPIES B].
When leaf sheet (cut sheet) is used, the [COPIES A] value is used for the number of
copies.
If the number of copies is specified in the application software, such as FineCut/Coat9,
set the number of copies to [1].
A
B
l
Speed limit setting [SPD LIMIT]
Setting Details
0 to 60 cm/s Sets the speed limit for high-speed movement for continuous copies.
Depending on the sheet type, the sheet may slip during high-speed movement,
preventing register marks from being correctly detected. Limit the movement speed in
such cases.
Set to [0] if the speed is not to be limited.
l
Skew check setting [SKEW CHECK]
Setting Details
OFF, 1 to 99 mm Sets the permissible sheet offset for continuous copying.
With continuous copying using roll sheets, gradual shifting may occur due to
sheet tilt.
Cutting is paused if the B axis coordinate for register mark 1 exceeds the setting.
Correct the sheet skew, then press the [ENTER/HOLD] key. The machine then
waits for register mark detection.
Use the jog keys to move the LED pointer illuminated point to the position shown
in the following figures, then press the [ENTER/HOLD] key. Registration mark
3