MIMAKI CG-100AR, Operation Manual

Page: 162 / 184

Chapter 8 Dealing with Problems
162
Checking Register Mark Sensor Responsiveness
• Responsiveness cannot be checked accurately by moving the head and sheet manually. Be
sure to check the register mark sensor responsiveness using the following procedure:
• For information on creating register marks, refer to "Creating Register Marks"(P. 80) .
• The pointer offset set using this operation will not be reset by [SETUP RESET].
• Enable the buzzer sound. (
"SET UP"(P. 135) > [BUZZER]) The detection confirmation
sound will not sound if the buzzer sound is disabled.
1
Attach a pen.
2
Load a sheet on which register marks are printed.
• Creating Register Marks
3
Press on the local mode screen.
• The machine switches to jog mode.
4
Use to move the pen nib close to the center of the register mark detection position.
• Register mark detection should be performed at a position at least 1 mm from the register mark.
Mark shape
Type 1 Type 2
Register mark
detection position
1 mm or more
Register mark
detection position
1 mm or more
5
Press the [END] key to exit jog mode.
• The system returns to local mode.
6
Press the [FUNCTION] key.
7
Use to select [MARK SENSOR], then press the [ENTER/HOLD] key.
8
Check to confirm that [Sensor Check] is displayed, then press the [ENTER/HOLD] key.
9
Set the register mark detection conditions.
• "Setting Register Mark Detection Conditions"(P. 85)
• The register mark detection conditions set are retained even when the power is turned off.