MIMAKI cg-100AP, Instruction Manual

Page: 126 / 180

3-18
COMPENSATION OF PLOTTING DISTANCE
There are some cases where an error is occurred between the length recognized by the plotter (move distance and
plotting of the plotter, cutting length and etc.) and actual length (the length actually measured with a ruler) de-
pending on the paper thickness. In order to plot out as accurate as possible, the compensated values shall be
registered here. The settings will be stored even if the power is turned OFF.
1 Set the pen on the magazine No.1.
Refer to Chapter 2 "Preparation of
Tools" (P.2-21).
More accurate compensation will be
enabled by using a separately-
available viewer.
2 S e t t h e p a p e r
Refer to Chapter 2 "PAPER SET-
TING" (P.2-25).
3 Select the offline mode.
Execute "DATA CLEAR" in this
chapter (P.3-4).
4 The third page of the menu will be
displayed under the offline mode.
5 Select [LENGTH], and the following
display will be appeared.
6 Set the size of plotting frame (rectan-
gular) of the X-axis. Assign the size
corresponding to the set paper. The
value will be changed whenever the
key is depressed. Select the appli-
cable value.
-F3+
: 250 - 5000mm (every 250mm step)
7 Select [PLOT]. Plot the frame to
actually measure the length, and the
following display will be appeared.
Remove the paper and actually
measure the values of [XR], [XL] and
[Y].
-F4+
CLEAR CORRECT
LENGTH : 250 PLOT
-F4+
X AXIS : XXXX. X [mm]
Y AXIS : XXXX. X Y:XXXX.X
<--SCALE AUTO FEED-->
<--COMPEN DIST-CMP-->
-PAGE+