MIMAKI cg-100AP, Instruction Manual

Page: 113 / 180

CHAPTER 3
APPLIED FUNCTIONS
3-5
PAPER CUTTING
Cut off the roll paper at an arbitrary position. When the paper end is misaligned, cut off so as to obtain the straight
edge.
Cutting after paper Load
1 Set the roll paper.
Refer to Chapter 2 "Roll Paper set-
ting" (P.2-25)
2 Select the offline mode.
Execute the procedure of this chapter
"DATA CLEAR" (the previous page).
3 Move the head to the position to be
cut off by using the JOG key.
4 Wait for two seconds, or press the
END
key.
5 Select [AUTOCUT].
6 Select [CUT OFF]. Execute the
paper cut off.
7 When the paper cut off has been
ended, the page will be returned to
the first page of the offline mode.
Cutting before Paper Load
1 Pull out the head of the roll paper on
the platen so as to locate the position
to be cut off on the synchro roller.
2 Select [AUTOCUT]. (With holding
the cramp lever at risen position)
3 Follow the display on the panel
h e r e a f t e r .
4 When the paper cut off has been
ended, execute the paper load, then
the page will be returned to the first
page of the offline mode.
or
JOG/ORG ) SET
XXXXXX. X , XXXXXX. X
-F4+
C U T M O D E : C U T P L O T
F O R C E : 3 8 0 g C U T O F F
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
END
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
-F4+
C U T M O D E : C U T P L O T
F O R C E : 3 8 0 g C U T O F F