MIMAKI cg-100AP, Instruction Manual

Page: 112 / 180

3-4
DATA CLEAR
The data clear is executed in the following cases
• When the mode is shifted from the online mode to offline mode.
• When the plotting is paused.
1 Confirm that no datum is received
under the online mode.
Display when no datum is received.
Display under receiving data
Display under receiving data and
executing the plotting
2 Select from the online mode to pause
m o d e .
After a little while, the following
display is appeared.
3 Select [CLEAR]
4 The data clear will be executed. The
display returns to the first page of the
m e n u .
• Execute the data clear after the plotter movement completely stops. If the
data clear is executed during movement, the data remains in the buffer.
This status may well cause a malfunction or erroneous operation when the
next online mode is selected. If the plotter side is unavoidably stopped in
advance, execute the following procedures.
1. Stop the data transmittion at the host computer side.
2. After confirming that the data transmission completely stops, ex-
ecute the [CLEAR] again.
-F1+
PLOT CANCEL
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
-F2+
ON LINE)
ON LINE) X
ON LINE)
#
1 X
20g 20cm 4.0G 0.00
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->