MIMAKI CFL-605RT, Operation Manual

Page: 135 / 170

4-19
1
1
1
4
Register Mark Reading
Functions
Confirm the following when failed in cutting correctly
Correct the light pointer position
If the plotter fails to recognize any registration mark properly, the possible cause is an error in the positional
relationship between the MARK sensor and the light pointer.
In this case, adjust the position of the light pointer.
1
Install a cutter in the tool holder.
2
Set the copy paper.
3
Confirm that the plotter is in the local mode.
4
Press the key.
5
Select [MARK SENSOR] by pressing the jog key
or .
6
Press the key.
7
Select [POINTER OFS] by pressing the jog key
or .
8
Press the key.
• A 10 mm by 10 mm cross pattern will be cutted.
• The light pointer turns on and moves to the center of the cross pattern.
9
By pressing the jog keys and , adjust the light pointer position so
that the center of the light pointer is in alignment with the center of the cross pattern.
10
Press the key.
• Registering the compensation value.
11
Press the key twice for terminating this function.
• The value registered in the [POINTER OFS] is not initialized even by executing the [SETUP RESET].
<
LOCA L >
A : S W I V E L
< F U N C T I O N >


S E T U P [ E N T ]
FUNCTION
< F U N C T I O N >


MA R K S E N S O R [ E N T ]
< MA R K S E N S O R >


S E N S O R O F S [ E N T ]
< MA R K S E N S O R >


PO I NT ER OF S
[ E N T ]
< L ED PO I NT ER >
A = 0 . 0 B = 0 . 0
< MA R K S E N S O R >


PO I NT ER OF S
[ E N T ]