MIMAKI CF3-1610, Operation Manual

Page: 30 / 166

1-16
Preparing the Cutting Panel
Attach the felt mat (Models R1, M).
If using Model R1 or Model M, attach the felt mat to the cutting panel.
Inserting the Work Guide Plates
Insert the work guide plates as a guide to keep the workpiece straight.
Insert them into the appropriate positions for the size of the workpiece.
• Insert a work guide plate into the holes
at each edge of the cutting panel.
• Felt mat retainer differs from types of the head used.
M model:Felt mat retainer A R1 model:Felt mat retainer B
• Use the felt mat retainer that suits the model that you will be using. Use of the incorrect type will result in
the protrusion of the felt mat retainer and this may hit the head.
• When a felt mat is put down on the cutting board with M model, use felt mat retainer B.
• When not using a felt mat, remove the felt mat retainer not to hit a head.
• When the work guide plate is mounted, be sure to adjust the head height and then turn the power on,
not to hit the head.
Felt mat
retainer B
Insert
(1) Put the felt mat on the cutting panel.
(2) Insert a felt mat retainer B into the holes at each edge of the
cutting panel.
• Insert the felt mat retainers B along the edges of the felt
mat.
• Set felt mat retainers on the positions circled in the right.
(6 places for CF3-1610)
Felt mat
Work guide
plates
Insert