MIMAKI CF2 Series, Operation Manual

Page: 119 / 186

— 3.23 —
ERROR 42 X OVERCURRENT
ERROR 43 Y OVERCURRENT
ERROR 46 PEN SENSOR
ERROR 50 X SENSOR
ERROR 51 Y SENSOR
ERROR 52
θ
ORIGIN
ERROR 53 Z ORIGIN
ERROR 70
θ
OVERLOAD
ERROR 71
θ
OVERCURRENT
ERROR 72 CUTTER Z LOAD
ERROR 73 ROLLER Z LOAD
ERROR 90 F/W
Errors that cannot be corrected by users
If any of the errors described below has arisen, immediately turn of the power to the device.
Wait for a while and re-turn on the power to the device. If the same message appears on the LCD,
immediately turn the power off and contact your local dealer or MIMAKI office.
Error message Error message
ERROR 00 MAIN ROM
ERROR 01 SERVO ROM
ERROR 02 MAIN RAM
ERROR 03 SERVO RAM
ERROR 04 EEPROM
ERROR 05 HANDSHAKE
ERROR 06 BUFFER
ERROR 08 POWER
ERROR 12 DEVICE ERROR 20
ERROR 20 I/O
ERROR 40 X OVERLOAD
ERROR 41 Y OVERLOAD
(*1)
" ERROR 70
θ θθ θ θ
OVERLOAD "
occurs when the head height is too excessive, and also when
θ rotation was performed without the tool of unit B reaching the work.
If
" ERROR 70
θ θθ θ θ
OVERLOAD "
occurs when the data is sent again after the tool is lowered
until it reaches the work, contact your local dealer or MIMAKI office.