MIMAKI CF-0907, Instruction Manual

Page: 81 / 170

— 2.33 —
Marking conditions for the crease roller
The following gives set values for crease conditions for the crease roller.
Set values
Speed: 0.2, 0.5, 1, 2, 5, 10, 15, 20, 25, 30 (cm/s)
Pressure: 1000 to 5000 (in increments of 100 g)
Acceleration: 0.1 to 0.3 (in increments of 0.1 G)
Up angle: 0 to 180 (in increments of 1 ° )
Ring distance: 0.00 to 2.50 (in increments of 0.05 mm)
Press correction: 0 to 1000 (in increments of 100 g)
Press (Y): –5000 to 5000 (in increments of 100 g)
Cutting conditions for the swievel blade
The following gives set values for cutting conditions for the swievel blade (optional).
Set values
Speed: 0.2, 0.5, 1, 2, 5, 10, 15, 20, 25, 30 (cm/s)
Pressure: 20 to 100 (in increments of 5 g)
100 to 200 (in increments of 10 g)
Offset: 0.00 to 2.50 (in increments of 0.05 mm)
Acceleration: 0.1 to 0.3 (in increments of 0.1 G)