MIMAKI 3042 MkII EX, Operation Manual

Page: 73 / 126

3-27
Chapter 3 Setup
3
2
2
2
Printing Check Flow
Nozzle check is conducted according to the following flow at the start of printing.
Printing Operations at “Nozzle Missing” Judgment and Error Occurrence

When judged to be “Nozzle Missing”
 Printing is stopped.

When error occurs during nozzle check
 Printing is stopped and “Printing Check” is automatically turned
OFF. After recovering from the error, set “Printing Check” once
again.
• Turn the “Printing Check” setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check

Judgment
2
3
Recovery operation

nozzle check

Judgment
4
Retry

Judgment
Printing Check

Judgment
Detects missing nozzles.
If more missing nozzles than “Judgement
Condition ” are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
5
Nozzle Missing judgment
If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
If more missing nozzles than “Judgement
Condition ” are detected after the recovery
operation, the recovery operation is conducted
again.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the “Printing Check” setting ON to be enabled.