Removing and Replacing Ouik-Lok® Cords (Fig. 1)
MILWAUKEE’S
exclusive Quik-Lok® cords provide instant
field replace ment or substitution.
1. To remove the Quik-LokO cord, turn the cord nut 1/4 turn
to the left and pull it out.
2. To replace the Quik-Lok® cord, align the connector key-
ways and push the connector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Installing Side Handle
MILWAUKEE
D-Handle Drills are supplied with a side han-
dle that can be installed on either side of the tool for right or
left handed use. To install the side handle, attach the side
handle to the extension. Thread it into the socket on the
desired side of the tool and tighten it securely. Because of the
high torque of this drill, the side handle must always be used
when operating the drill.
Ring Clamp Side Handle For Right Angle Drive Unit
For D-handle drill with Right Angle Drive unit:
A ring clamp, extension and side handle are supplied with the
Right Angle Drive Unit. When using a right angle drive unit,
attach the side handle to the ring clamp. Do not use the
extension when using the ring clamp. The ring clamp with
attached side handle clamps onto the right angle dirve unit
and can swivel 360
0
and locked tight in any position.
For D-handle drill without Right Angle Drive Unit:
When using the D-handle drill without the right angle drive
unit, remove the ring clamp with attached side handle, then
remove the side handle from the ring clamp. Attach the side
handle to the extension. The side handle can be installed on
either side of the tool for right or left handed use. To install the
extension with attached side handle, thread it into the socket on
the desired side of the tool (for right or left-handed use) and
tighten securely.
NOTE:
If you have an extra ring clamp with attached side
handle and extension with attached side handle, do not use the
extension with attached side handle when using the right angle
drive unit. Remove it from the tool.
(Continued on next page)
Milwaukee Tool
Heavy Duty, Reversing, 1/2” D-Handle Drill
Model Numbers: 3107-6 (kit)
Operating Instructions
Page 1
RenTrain INC
RenTrain INC
To reduce the risk of injury, always unplug tool
before attaching or removing accessories. Use
only specifically recommended accessories.
Others may be hazardous.
WARNING!
To reduce the risk of injury, always use a side
handle when using this tool. This tool operates
with high torque. Always brace or hold the tool
securely.
WARNING!
ASSEMBLY
Fig. 1
When using the D-Handle drill without the right
angle drive unit, do not clamp the ring clamp
with attached side handle to the front of the
gear case; use the side handle instead.
Do not use the extension when using the ring
clamp.
WARNING!
