PL-601
EnviroRanger Installation Guide
Page 21
In
s
ta
lla
tio
n
SmartLinx Modules
1. Align SmartLinx card with the two mounting posts, and press-fit with the
female connector.
2. Use the screws supplied with the SmartLinx module to attach it to the
mounting posts.
3. Wire the SmartLinx card in according to SmartLinx Manual.
Analog Input /Output Cards
1. Remove the plastic shield.
2. Pry the top and bottom mounting brackets away from the unit as shown
below.
3. Align the I/O card with the 36 pin male connector and the four standoffs.
4. Press fit the I/O card until it ‘snaps’ into place.
5. Replace the mounting brackets and the plastic shield.
6. Slide the EnviroRanger back into place.
7. Wire the cards as shown in the Optional Card Wiring table on page 29.
Expansion Memory
1. Align the optional Expansion Memory to the male connector.
2. Push-fit the Expansion Memory Card into place.
I/O card
plastic shield
standoffs
mounting bracket