Milltronics airanger XPL plus, Instruction Manual, Page: 61 / 114

7ML19981AN02 AiRanger XPL Plus – INSTRUCTION MANUAL Page 57
mm
mmm
Enhancement P
a
ra
met
e
rs
Scanning Parameters (P720, P725 to P729)
P720 SMART SCAN
Select the condition(s) to add / remove the Point Number displayed to the Priority
Point scan sequence (as indicated by the display symbol in the RUN mode).
In the RUN mode, if any of the conditions occur, Priority Point(s) are scanned
each time a non-priority point is scanned. Otherwise, all vessels are scanned in
numerical sequence.
Selecting "manual" allows the addition or removal of Priority Points by the
following methods:
• pressing on the local keypad
• sending an MT12 / MT13 message via the BIC-II (see
Technical Reference
)
• sending the appropriate message via compatible industry bus
values: 0 = off (numerical sequence only) (preset)
1 = manual
2 = Filling Indicator (P702) value exceeded
3 = Emptying Indicator (P703) value exceeded
4 = Filling / Emptying Indicator value exceeded
5 = Filling Indicator or Failsafe Timer (P070) exceeded
6 = Emptying Indicator or Failsafe Timer (P070) exceeded
7 = Filling / Emptying Indicator or Failsafe Timer exceeded
8 = Failsafe Timer exceeded
P725 AUXILIARY TRANSDUCER
Use this feature if a long range transducer measurement range, but a short
range transducer Nearest Distance (see Installation Transducer Mounting) is
required. In the RUN mode, if the material level is within the short range
transducer measurement range, that measurement is processed. Otherwise, the
long range transducer measurement is used.
With the long range transducer Point Number displayed, enter the short range
Point Number.
values: 0 to 10 (0 = off, preset)
P726 LEVEL SYSTEM SYNC
Use this feature if another level measurement system is mounted near the XPL
Plus.
See
Installation
Interconnection-Level System Synchronization.
values: 0 = not required
1 = synchronize level monitors (preset)