Milltronics airanger XPL plus, Instruction Manual, Page: 34 / 114

Page 30 AiRanger XPL Plus – INSTRUCTION MANUAL 7ML19981AN02
mmmm
m
Applicat
ion P
a
ra
met
e
rs
Failsafe Parameters (P070 to P072)
As preset, in the event of a measurement or technical difficulty, the XPL Plus holds the
Reading, Bar Graph, SAM-20 relays (if used) and AO-10 mA outputs (if used), at their last
known values.
To operate process control equipment under these conditions, alter the following
parameters as required.
If alternate Failsafe Operation is not required, proceed to RELAY PARAMETERS.
P062 OFFSET READING
Enter the value to be added to the Reading, (before display).
This feature is preset to 0.000, (no offset).
e.g. To reference a material level to sea level, enter the distance in Units
(P005), between Empty (P006) and sea level. (Enter a negative value if
Empty is below sea level.)
This feature affects the XPL Plus (and BIC-II, if used) Reading only. (Relays and
mA outputs are not affected).
values: -999 to 9999
vessel
display offset
(P062)
sea
level
Empty
(P006)