Milli-Q Millipore, User Manual, Page: 88 / 92

88 Milli-Q® Reference System
Summary of Alert messages
Alert messages
LCD message What it means
CALIBRATION VISIT OVERDUE XX
DAYS The System has determined that a
Calibration Visit is overdue.
Contact Millipore SAS.
CHECK UV 185 NM LAMP The UV 185 nm Lamp is not turning on.
Contact Millipore SAS.
EXAMINE INLET STRAINER The System has determined that it is time
to clean the Inlet Strainer.
Clean the Inlet Strainer and reset the
message.
MILLI-Q FEED CONDUCTIVITY >
SP The measured feedwater conductivity is
> Set Point.
Check the source of feedwater and its
conductivity.
MILLI-Q INTERMEDIATE
RESISTIVITY <SP, PLEASE ORDER
Q-GARD® AND QUANTUM® The measured resistivity after the
Q-Gard® Pack is < Set Point.
The Q-Gard® Pack and Quantum®
Cartridge are replaced together. Contact
Millipore SAS about ordering a
replacement Q-Gard® Pack and
Quantum® Cartridge.
NEXT CALIBRATION VISIT IN XX
DAYS The System is prompting you that a
Calibration Visit should be scheduled.
Contact Millipore SAS.
NEXT QUALIFICATION VISIT IN XX
DAYS The System is prompting you that a
Qualification Visit should be scheduled.
Contact Millipore SAS.
NEXT SERVICE VISIT IN XX DAYS The System is prompting you that a
Service Visit should be scheduled.
Contact Millipore SAS.
NO RESPONSE FROM DHCP
SERVER Contact your network administrator.
Restart the System.
QUALIFICATION VISIT OVERDUE
XX DAYS The System has determined that a
Qualification Visit is overdue.
Contact Millipore SAS.
REPLACE POD PAK The System has determined that the POD
PAK needs replacement.
Replace the POD Pak and reset the timer.
REPLACE POD PAK IN XX DAYS The System has determined that the POD
PAK should be replaced in XX days, where
XX is 15, …, 1.
Replace the POD Pak and reset the timer.
Continued on next page