Miller Syncrowave 250 DX, Owner'S Manual

Page: 36 / 82

OM-363 Page 30
4-5. Output Control
1 Output Control
!
Weld output terminals are ener-
gized when power is On, and Out-
put On LED is lit.
Use control to select front panel, trigger
hold, or remote output control.
NOTE: Lit LED indicates selected mode.
For weld output, press button to toggle LED
to On position.
2 Remote Trigger (Standard) Operation
For remote output control, press button to
toggle LED to Remote position (see Sec-
tion 3-9).
Torch trigger operation is as shown.
NOTE: Initial weld amperage and final am-
perage is controlled by the remote device,
not by the welding power source.
NOTE: If On/Off only type trigger is used,
it must be a maintained switch. All func-
tions become active.
Application: Use Remote Trigger when
the operator desires to use a foot pedal or
finger amperage control.
When Output Selector switch (see Section
4-2) position changes, Output control LED
will always switch to Remote.
Remote (Standard)Torch Trigger Operation
Current (A)
Preflow
Initial Amps
Final Slope
Postflow
Weld Amps
Final Amps
Release For
Maintained Switch
Remote (Standard)Torch Trigger Operation
Release Foot Or
Finger Remote
Control
Push & Hold
Foot Or Finger
Remote Control
1
2
(CE Nameplate)
1
2