Miller OM-246 466B, Owner'S Manual

Page: 48 / 76

OM-246 466 Page 44
4-16. Checking Program Revision
To enter the program revision mode, turn on welding power source, and press and hold the Setup push button in until
PCM ###X appears on the display (message appears in approximately 15 seconds). Rotate Adjust knob to check the
program revision level of each module as follows:
PCM (Process Control Module)
###X
UIM (User Interface Module)
###X
WFCM (Wire Feed Control Module)
###X
AIM (Automation Interface Module)
###X
To continue welding power source start up process after viewing program revision levels, press the Arc Control push
button.