OWNER’S MANUAL
OMĆ207 132
October 2001
Mig Runner Cart (195 445)
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off welding power source and input disconnect
device.
•
Disconnect input plug or power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
•
Keep cylinders away from welding and other
electrical circuits.
•
Never touch cylinder with welding electrode.
•
Always secure cylinder to running gear, wall, or
other stationary support.
FALLING EQUIPMENT can cause injury
and damage, OVERSIZED CYLINDER
can cause tipping.
•
Properly install and secure all equipment onto cart
before using cart.
•
Always secure or remove any tools stored on cart
before moving unit.
•
Do not lift cart in any manner when equipment and
cylinder(s) are installed – use handles to move cart.
•
Do not overload handles with cables – use standard
10 to 15 foot cables as maximum lengths.
•
Do not move cart where two wheels are at diffrent
heights and cart could tip – avoid tipping.
•
Be careful when moving unit over uneven surfaces.
803 117
1
2
1
Handles
Install handles with the rubber grips
pointing downward and outward as
shown using supplied 3/8–16 nuts
bolts.
2
Cylinder Chain
Install the center clip of the cylinder
chain to the center hole of the bottle
mounting bracket as shown.
.
The bottle mounting bracket
can be moved to the middle
shelf to accommodate two
small bottles or one small and
one large bottle.
3
Lag Bolts
Remove the six lag bolts from the
skid, slide the cart forward, remove
front skid support. Roll cart off skid.
.
The power source may or may
not be already mounted in the
Mig Runner Cart
Tools Needed:
5/16, 9/16 in
9/16 in
3
Figure 1. Installing Running Gear/Cylinder Rack
