Miller FILTAIR, Owner'S Manual

Page: 27 / 40

OM-239026 Page 23
7-2. Overload Protection
OM-239026 Page 20
7-2. Overload Protection
246152-C
! Turn off unit and disconnect
input power cord.
1 Fuse F1 (See Parts List For
Rating)
F1 protects the electrical compon-
ents of the filter cleaning system from
overload. If F1 opens the filter clean-
ing system does not operate. Re-
place F1 if open.
To access F1, loosen clamp on lower
flex duct and raise flex duct. Reinstall
flex duct after checking fuse.
2 Circuit Breaker CB1
CB1 protects the blower motor from
overload. If CB1 opens the blower
motor will not run.
To access CB1, reach under front
panel.
To reset CB1, reach under front pan-
el and place CB1 in the On (up) posi-
tion.
If a fuse or circuit breaker opens,
it usually indicates a more seri-
ous problem exists. Contact a
Factory Authorized Service
Agent.
Tools Needed:
1
2
Fuse Puller
OM-222 Page 1
NGO’s
tools/
helmet weldshield faceshield
glasses hairdryer cclamp rpmmeter benchvise
popriveter
oilcan filtersocket hacksaw belttensiongauge sealant_1
snapringpliers linepliers pencil fusepuller mallet scissors
tape
rubbergloves weldgloves earmuffs electrodewrench
pinextractor2
tip_dress
sealant_2 pump pliers
T_allen
pinextractor (141761)
SOAP
bar soap
Liquid soap
Paper Clip
Needle-Nose Vise Grip
Ground Strap
Thermal Compound
Trowel
Chisel
Torx
ear plugs
Turn off power and disconnect in-
put power cord.
1 Fuse F1 (See Parts List For Rating)
F1 protects the electrical components of the
filter cleaning system from overload. If F1
opens the filter cleaning system does not op-
erate. Replace F1 if open.
To access F1, loosen clamp on lower flex
duct and raise flex duct. Reinstall flex duct
after checking fuse.
2 Circuit Breaker CB1
CB1 protects the blower motor from over-
load. If CB1 opens the blower motor will not
run.
To access CB1, reach under front panel.
To reset CB1, reach under front panel and
place CB1 in the On (up) position.
�
If a fuse or circuit breaker opens, it usu-
ally indicates a more serious problem
exists. Contact a Factory Authorized
Service Agent.