OM-275857 Page 63
SECTION 10 – MEMORY
10-1. Memory (Program Storage Locations 1–9)
OM-275857 Page 13
SECTION 3 MEMORY
3-1.
Memory (Program Storage Locations 1-9)
Memory Locations
1 9
AC
DC
TIG (HF or Lift)
TIG (HF or Lift)
Stick
Stick
And
And
And
2
3
2nd
3rd
1st
1
For Dynasty Models, each memory location (1 thru 9) can store parameters for both
polarities (AC and DC), and each polarity can store parameters for both process (TIG
and Stick) for a total of 36 programs.
For Maxstar Models, each memory location (1 thru 9) can store parameters for both
process (TIG and Stick) for a total of 18 programs.
OM-275857 Page 15
SECTION 4 MEMORY
4-1.
Memory (Program Storage Locations 1-9)
1
Memory (Program Storage 1-9)
Switch Pad
2
Polarity Switch Pad (Dynasty
Only)
3
Process Switch Pad
To create, change, or recall a weld-
ing parameters program, proceed
as follows:
First, press Memory switch pad until
the desired program storage location
(1-9) is displayed.
Second, press Polarity switch pad
until the desired polarity, AC or DC,
LED is lit
Third, press Process switch pad until
desired process, TIG HF Impulse,
TIG Lift Arc, or Stick, LED is lit.
The program at the chosen location,
for the desired polarity and process, is
now the active program.
Fourth, change or set all desired
parameters.
2
3
2nd
3rd
1st
Memory Locations
1 9
DC
TIG (HF or Lift)
Stick
For Maxstar Models, each memory location (1 thru 9) can store parameters
for both process (TIG and Stick) for a total of 18 programs.
And
1
1
Memory (Program Storage 1–9) Button
2
Polarity Button (Dynasty Only)
3
Process Button
�
Polarity and AC Waveshape controls
are available on Dynasty models only.
To create, change, or recall a welding pa-
rameters program, proceed as follows:
First, press Memory button until the desired
program storage location (1-9) is displayed.
Second, press Polarity button until the de-
sired polarity, AC or DC, LED is lit.
Third, press Process button until desired
process, TIG HF Impulse, TIG Lift Arc, or
Stick, LED is lit.
The program at the chosen location, for the
desired polarity and process, is now the ac-
tive program.
Fourth,
change
or
set
all
desired
parameters.
Each memory location (1 thru 9) can store
parameters for both polarities (AC and DC),
and each polarity can store parameters for
both process (TIG and Stick) for a total of 36
programs.
Summary of Contents for Dynasty 400
