OM-2240 Page 38
6-2. Output Control And Trigger Functions
A. Remote (Standard) Torch Trigger Operation
Current (A)
Preflow
Initial Amps
Initial Slope
Final Slope
Postflow
Main Amps
Final Amps
R
R
P & H
Maintained Switch
Foot Or Finger
Remote Control
P&H = Push trigger and hold
R = Release trigger.
NOTE: When a foot or finger remote current control is connected to the welding power source, initial amps, initial slope, final slope
and final amps are controlled by the remote control, not by the welding power source.
B. Remote 2T Torch Trigger Operation
Current (A)
Preflow
Initial Amps
Initial Slope
Final Slope
Postflow
P&R
Main Amps
Final Amps
P&R
P&R = Push trigger and release. NOTE: If torch trigger is held more than 3 seconds, operation reverts to RMT STD (Remote Standard) mode.
