OM-281136 Page 37
7-4. Preheating Without A Loaded Program
1. Ensure all control thermocouples (TCs) are securely located under the attached heating tools and in positive contact with the part to be
heated. The attached TCs will display sensor temperatures.
2. Press
[Run]
to start the heating process. The recording indicator will flash and the recording timer will display duration of the heat cycle.
3. When target temperature is reached under the heating tool, verify joint temperature is within range before welding.
4. Press
[Stop]
to end the heating cycle. A message is displayed asking if recording should be stopped. Press
[Stop Recording]
to end the
recording or
[Continue Recording]
to keep recording.
7-5. Bakeout Without A Loaded Bakeout Program
Figure 7-6. Bakeout No Preconfigured Loaded Program w/Parameters Screen
1. When on the temperatures screen, press
[Bakeout]
to view the Bakeout menu.
2. Press
[Up/Down Arrows]
to select parameter to change.
3. Press
[Decrease –]
or
[In]
to adjust values.
4. While on the
Bakeout: OFF/ON
field, press
[Select]
to change from
OFF
to
ON
and enable the Bakeout process.
.
If output is on, Bakeout will begin as soon as
ON
is selected.
.
5. Press
[Temperatures]
to return to the thermocouples screen.
6. If output is off (SETTINGS is displayed), press
[RUN]
to begin heating. The heater will ramp up to the Bakeout Target Temperature, Soak for
the programmed duration and Ramp down to the End Temp. See Figure 7-8 for example screen images.
7. When the Bakeout sequence is complete, a message is displayed to press
[Stop]
. After pressing
[Stop]
, a second message is displayed
asking if recording should be stopped. Press
[Stop Recording]
to end the recording or
[Continue Recording]
to keep recording. See
