Miller 907684001, Owner'S Manual

Page: 61 / 92

.
A complete Parts List is available at www.MillerWelds.com
OM-270536 Page 53
SECTION 10 − MAXSTAR 210 DX OPERATION
10-1. Maxstar 210 DX Controls
2
5
4
6
1
247216-A
.
For all front panel switch pad controls:
press switch pad to turn on light and en-
able function.
.
Green on nameplate indicates a TIG
function, Gray indicates a Stick func-
tion.
1 Standby Button
Use to put machine into low power
consumption mode.
.
This button can also be used to clear
some errors. See Section 12-3.
2 Amperage Adjustment Control
Use amperage adjustment control control in
conjunction with applicable front panel func-
tion switch pads to change values for that
function.
3
Memory Card Port And Indicator
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed.
4
Volt Meter
Displays actual voltage when voltage is
present at the weld output terminals. It is also
used to display parameter descriptions
while in the menu.
5 Ammeter
Displays actual amperage while welding and
preset amperage while idle. It is also used to
display parameter selection options while in
the menu.
6
Amperage Control
Use this control in conjunction with the am-
perage adjustment control to set the weld
amperage or peak amperage if the Pulser is
active.
3