Miller Electric Millermatic 350P, Owner'S Manual

Page: 50 / 68

.
A complete Parts List is available at www.MillerWelds.com
OM-254915 Page 46
6-14. System Menu
Ref. 242 929-C
1 Lit Indicators
To access the system menu press
both the setup button and the Arc
Control button at the same time.
Once on the system menu the left
adjustment knob scrolls through
the options.
1 1
6-14-1. Arc Hours
This menu reports the arc time in hours. “HRS” “XX.X”
6-14-2. Arc Starts
This menu reports the number of arc starts. “ARCS” “XXXX”
6-14-3. User Interface Software Version
This menu reports the software version of the User Interface Board. “IXXX” “XXXX”
6-14-4. Control Software Version
This menu reports the software version of the Control Board. “CXXX” “XXXX”
6-14-5. Gun Calibration
This menu allows the user to run gun calibration. See Section 6-15 for more information. “G.CAL” “XXXX”
6-14-6. Hot Start Enable (Pulse only)
This menu allows the user to enable the hot start feature. Hot start can be turned on (“ON”), turned off (“OFF”), or turned to automatic settings
(“AUTO”). The automatic settings are the preset factory recommended parameters. For more detailed information on Hot Start see Section 6-17.
6-14-7. Crater Fill Enable
This menu allows the user to enable and disable the crater fill feature. For more information see Section 6-18.
6-14-8. Trigger Schedule Select
This menu allows the user to enable and disable the dual schedule feature. For more information see Section 6-16.