Milestone MacroPATH Basic QX Series, Operator'S Manual

Page: 6 / 128

MacroPATH and MacroPATH Basic QX Series MM161-001
– Operator Manual
6
1. INTRODUCTION
1.1. Symbols used
The instructions marked with this symbol are important and must be read carefully.
An instruction accompanied by this WARNING symbol means you need to proceed
with caution. Failure to follow the instruction may endanger the user or cause damage
to the instrument.
Biohazard.
CE logo: this instrument complies with European Community directives.
IVD medical device according to directive 98/79/EC.
Symbol of the European WEEE directive (2002/96/EC):
electric/electronic material, do not dispose of in the environment.
Manufacturer.
Fragile
1.2. Introduction to MacroPATH and MacroPATH Basic
MacroPATH and MacroPATH Basic were designed to obtain images of histological samples and to ensure
their complete, safe and reliable handling.
MacroPATH and MacroPATH Basic differ by the fact that MacroPATH Basic does not include the PC Monitor
(see chapter 2.1).
The system has been designed for use in a laboratory and can therefore withstand the harshest laboratory
conditions (indoor use only).
MacroPATH's measurement function is strictly linked to the calibration performed by the
operator and is not controlled by the unit's software. That is why the measurements of
the sample obtained with MacroPATH CANNOT be taken into account for diagnostic
purposes. These values are purely indicative.
Indeed, a ruler must be placed near the sample (see image below) or a gauge must be used to obtain
a diagnostic value for the growth of the tumour, the extent of the lesion, etc.
The system must be calibrated in order to perform measurements with MacroPATH (refer to chapter 3.6.6
for the calibration procedure).