Page 5 of 17 rev 103020 Millennia Media HV-316
Front Panel Functions
The 3/8” thick hand
-machined aluminum front panel
consists of 48 LED status indicators and a two-digit
numerical display.
Ælogic software is required to operate the HV-316.
The most current version can be downloaded at
. Scroll down to the Downloads
section. It requires a computer running MS Windows
10 or higher.
1.
Unit ID Display
–
Indicates unit number assigned
to preamp
.
2.
Power Indicator
–
Decimal point indicates unit
has power. It takes about 20 seconds after
power up before the Unit ID Display comes on.
3.
Input Level & Phantom Power Indicator
–
Green indicates levels -46 dBFS and higher. Red
indicates 0 dBFS. Amber indicates phantom
power is on.
4.
Auxiliary Power
–
Indicates 12V auxiliary
(redundant) power source is powering unit.
5.
Power Switch
–
Turns the unit on and off.
Rear Panel Functions
1.
AC Power
–
IEC power inlet, 80-264 VAC 47-63 Hz
2.
MIDI Connection
–
Allows remote control of the
HV-316 using MIDI protocol. Use with Yamaha
break-out cable ZP893500
3.
Ethernet
–
Dante audio networking and Ælogic
control. Ælogic is only available on the Network
Primary connector
4.
Network Reset
–
Restore to factory default
settings. Static IP address 192.168.1.221, Netmask
255.255.255.0
HV316 must be powered off.
Insert a small non-metallic object into the reset
opening on the read of the unit. You should feel a
slight click when the reset button is depressed.
Turn on the unit while continuing to hold the reset
button.
When the unit processor has reset it will display “00”
in the Unit ID display on the front of the unit.
Release the reset switch on the rear. The unit will
continue to boot.
When the ID Display switches to the selected Unit
ID, the device is ready to use. It will have the factory
profile and will be set to Static IP address
192.168.1.221, Netmask 255.255.255.0.
5.
12 Volt Redundant (Auxiliary) Power
–
Connect only Millennia approved optional backup
power supply here.
6.
Unit ID Selector
–
Address Select
Rotary
Switch sets Unit ID. The front panel numeric
display changes to reflect the value selected
here. If connected to a network, the power
needs to be cycled for the change to take effect
in Ælogic.
7.
Mic Inputs
–
Eight channels of
microphone-level input wired in the AES59/
8.
Analog Output Option
–
DB25s wired in the
AES59/Tascam format for analog outputs. This
option must be added at the factory.
9.
Reserved DB25
–
for future options.
Address
1
2
3
4
5
6
7
8
Unit ID
1
2
3
4
5
6
7
8
Address
9
A
B
C
D
E
F
0
Unit ID
9
10
11
12
13
14
15
16
2
1
3
5
3
4
1
5
2
4
2
3
1
5
6
8
7
5
2 3
8
9
9
1
4 6
7
7
8
