Mikrotron EoSens CAMMC1186, Reference Manual, Page: 39 / 98

Acquisition Control
MIKROTRON GmbH 5 ‐ 5
TriggerSource
This feature defines the source of the trigger signal.
TriggerSoftware
This feature generates an internal trigger.
Tip: When using Trigger ‐
Software, the exposure time
of the next frame cannot be
defined by TriggerWidth of
the feature ExposureMode.
Instead, it has to be defined
by the feature Exposure ‐
Time.
Access
read / write
Type
enumeration
In
Line0
Line1
Software
CXPTrigger
CXP cameras with DIN connector offer one trig ‐
ger input with two physical lines via the 12 pin
Hirose connector (see page 3
‐ 7); the trigger sig ‐
nal can either be sent via line 0 or line 1
CXP cameras with DIN connector offer one trig ‐
ger input with two lines via the 12 pin Hirose
connector; the trigger signal can either be sent
via line 0 or line 1
if TriggerSoftware is set, the trigger will be gener ‐
ated by the software using the feature Trigger ‐
Software; no external (hardware) trigger signal is
needed
if CXPTrigger is set, the camera will wait for an
external trigger signal from the frame grabber
before acquiring another frame; exposure time
for the next image is the time defined in the fea
‐
ture ExposureTime
Out
The active source is available at OUT0 of the connected camera.
Remark
Only one trigger source can be active.
Access
write
Type
command
In
0x00000001
Out
—
Remark
In order to generate a software trigger signal, “Software” has to
be set in TriggerSource.