Mikrotron EoSens CAMMC1186, Reference Manual, Page: 22 / 98

The 1.1CXP Camera
MIKROTRON GmbH 3 ‐ 4
Interfaces of the Camera
At the rear of the camera you find one:
1) status LED
in order to verify the operating status of the camera
2) CoaXPress DIN1.0/2.3 connector with four channels
which is used to connect the camera with a CoaXPress compli ‐
ant frame grabber. It can supply the camera with power via
power over coax (PoC)
Tip: Before connecting an
external trigger, check the
pinning of the Hirose con ‐
nector, described on page 3 ‐
7. In addition, take the trig ‐
ger settings into account.
For more information see
" Acquistion Control " on
page 5 ‐ 2.
3) 12 pin Hirose power connector
which is used when an external power supply (12 ‐ 24V) has to
be connected, an external trigger is connected and/or an out ‐
put signal is used.
Image 3 ‐ 1: 1.1CXP camera with DIN connector
1
2
3