1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
DC power connector 48 – 57 V.
DC power connector 18 – 30 V.
LED indicating a power state of the device.
Reset button.
Gigabit Ethernet, 8 - ports, delivering PoE out.
Gigabit Ethernet, 8 - ports, delivering PoE out.
Two - 10G SFP+ ports.
LED Indicating the activity of SFP port.
LED Indicating the speed of SFP port.
Configuration
The device can be discovered using Winbox utility, by clicking on the Neighbors list. The default management address is 192.168.88.1. To reach both
devices needs to be in the same IP network. Configured as a bridge, ARP, and fast forward enabled. RSTP protocol activated.
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities:
.
For recovery purposes, it is possible to boot the device for reinstallation, see section
.
Buttons and Jumpers
Powering
The device accepts power in the two ways following ways:
Direct-input power jack 1, (5.5 mm outside and 2 mm inside, female, pin positive plug) accepts 18-30 V DC.
Direct-input power jack 2, 48-57 V DC .
Use included DC plug to connect with your power source:
DC plug 2.1x5.5x12 mm to Screw Terminal 2pin.
Connect your power source cables to the two pins and secure them in place by tightening screws.
Connect DC plug to the device.
The power consumption under maximum load can reach 21 W, with attachments 325 W.
Power output
