2
3
click
BOARD
™
www.mikroe.com
2. Soldering the headers
3. Plugging the board in
Once you have soldered the headers your
board is ready to be placed into the desired
mikroBUS
™
socket. Make sure to align the cut
in the lower-right part of the board with the
markings on the silkscreen at the mikroBUS
™
socket. If all the pins are aligned
correctly, push the board all
the way into the socket.
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
the bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
Before using your click board
™
, make sure
to solder 1x8 male headers to both left and
right side of the board. Two 1x8 male headers
are included with the board in the package.
4. Essential features
IrThermo 2 click is a non-contact temperature
measurement solution, ideal for monitoring
hard to reach objects (too far, inconveniently
placed, hazardous, fluid etc.). The sensor
absorbs the infrared radiation emitted by
the target object (within the sensor’s field
of view) and the integrated math engine
calculates its temperature by comparing it
with the temperature of the silicon die. The
sensor is factory calibrated, but the user can
adjust the calibration coefficients for specific
applications (to correct for range, field of view,
object shape and environmental factors).
1
IrThermo 2 click carries the
TMP007
infrared
thermopile sensor with an integrated
math engine. The measurement range
of the sensor is between –40°C to 125°C
(with a 14-bit resolution). IrThermo 2 click
communicates with the target board MCU
through mikroBUS
™
I
2
C pins (SCL, SDA);
there’s also an Alert pin in place of the default
mikroBUS
™
INT. The board is designed to use
either a 3.3V or a 5V power supply.
IrThermo 2
click
1. Introduction
IrThermo 2
click manual
ver 1.00
0100000079140
