and flames, and call 911. Safety information can be obtained
from your local gas suppliers.
When using this equipment, safety precautions
should always be followed, including the following:
The griddles burners, grates and outside surfaces may become hot
after using, so you must be careful to touch;
During operation, do not directly touch burners and plates;
Turn off the equipment as not in using, cleaning, servicing or
adjusting any parts or attachments.
If the equipment has any problems of equipment damage, gas
piping leaks, igniter or valves damage, or lose product accessories, do
not operate by yourself and call for the service immediately;
The attachments not recommended or sold by the manufacturer
may cause fire, personal injury, even death;
Do not use out of doors;
The equipment is used for grill, not available for any other using;
The equipment does not contain any user-serviceable parts.
Dealers or technicians will repair it. Do not take apart any spare parts
without authorization;
Never change any other parts without authorization to this
equipment, otherwise, may cause hazards, and the
manufacturer has
the right not to provide warranty service;
Steel cutting producers used to manufacture with sharp edges. The
manufacturer has dealt with these sharp edges during production,
however, we insist the operator take care when in contact with this
piece of equipment;
Always keep hands, hair and clothing away from heating source.
Wait the unit cools down before you cleaning. Because the unit is
too hot to handle after using.
8. Operating Instructions
Before operating, make sure place the unit horizontally by adjusting
bottom adjustable legs, and place the catch tray properly.
The pilot light has been set at the factory. Each burner has a pilot
light.
8.1：Lighting the pilot light
Turn the control valve at the position of “0”(Fig.2), make sure all
knobs are in the close state. Light and hold an ignition source at the
pilots. The pilot light may not be lighted immediately, for existing gas
in the pipe. Wait a minute, the pilot light will be lighted after the gas
extinguished.
9
