Frequently Asked Questions
Fault message after a program has been interrupted
Problem
Possible cause and solution
Drainage. See
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum drain height is 1 m.
Water intake. See
The water inlet is blocked or restricted.
Check whether the faucet is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
The drain pump is activated for 2 minutes. The
washing machine door is then released. Wait for the
drain pump to stop before switching the washing
machine off.
Waterproof system
Turn off
Service
The water protection system has reacted.
Close the faucet.
Contact Miele Service.
Service Fault F
There is a fault.
Disconnect the washing machine from the
electrical supply. Unplug the appliance or switch
off the circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the electrical supply.
Then switch the washing machine on again.
Restart the program.
If the fault message appears again, contact Miele
Service.
To switch off the fault message: Turn the program selector to the
position and
switch the washing machine off.
63
Summary of Contents for WXF 660
Page 104: ...M Nr 11 669 330 04 en CA WXF 660 ...
