Fitting a door front panel made
by another manufacturer
Preparing the front panel
A
Measure distance
X
for drilling the
hinge holes.
– with spacer bars:
– without spacer bars:
(the front panel must be
correspondingly higher)
B
Mark the two hinge holes and the
four smaller holes as shown in the
diagram.
– front panel shown decor side face
down, upper edge at the bottom:
if width
b
increases, measurement
a
must also be increased
b
= 592 mm
N
a
= 21.5 mm
b
= 593 mm
N
a
= 22.0 mm
b
= 594 mm
N
a
= 22.5 mm
b
= 595 mm
N
a
= 23.0 mm
b
= 596 mm
N
a
= 23.5 mm
The height of the door front panel
H
corresponds to the door height of the
adjacent units.
C
Drill the two hinge holes (
C
35 mm/
15.5 mm deep) in the back of the
front panel.
D
Next, drill the four smaller holes (
C
7
mm/10 mm deep) in the back of the
front panel.
Installation and connection
74
