Problem solving guide
103
General problems with the dishwasher
Problem
Cause and remedy
The dishwasher fails to
react when buttons are
pressed. The display and
indicator lights remain
dark.
The dishwasher has switched itself off after the set "switch
off after" period to save energy.
Press the
button to switch the dishwasher back on.
The following fault
message appears in the
display:
Salt container lid not correctly
closed
The salt reservoir lid has not been closed properly.
Close the salt reservoir lid.
The cleaning agent
dispenser lid cannot be
closed properly.
Residual cleaning agent is blocking the catch.
Remove the cleaning agent.
At the end of a programme
there is a film of moisture
on the inside of the door
and the interior cabinet
walls.
This is not a fault.
It is caused by the drying system.
The moisture will dissipate after a short while.
Water remains in the wash
cabinet at the end of the
programme.
(This does not apply to the
"Super short"
programme).
Before rectifying the problem:
Switch the dishwasher off with the
button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and care").
The drain pump or non-return valve may be blocked.
Clean the drain pump or the non-return valve (see
"Maintenance").
The drain hose is kinked.
Remove any kink from the drain hose.
The on-site drain siphon is blocked.
Check and clean the drain siphon.
Summary of Contents for PG 8058
Page 123: ......
