Programming
45
You can adapt the programming of the
hob to your personal needs. Several
settings can be altered in succession.
After accessing programming mode,
the
symbol appears and
will ap-
pear in the timer display. After a few
seconds
:
(Programme 01) will flash
alternately with
:
(Code) in the timer
display.
Change programming
Accessing programming mode
The
sensor is located approx.
1 cm (index finger width) to the left of
the
sensor.
With the hob switched off
, touch
the
and
sensors at the same
time until the
symbol and
ap-
pear in the timer display.
Setting a programme
For a two digit programme number
you need to first set the tens position.
Whilst the programme is visible in the
display (e.g.
:
), touch
the
sensor repeatedly until the
number for the programme you want
appears in the display or touch the
appropriate number on the numerical
keybank.
Setting the code
Whilst the code is visible in the dis-
play (e.g.
:
), touch the
sensor
repeatedly until the number for the
code you want appears in the display
or touch the appropriate number on
the numerical keybank.
To save the settings
While the programme is showing in
the display (e. g.
:
) touch the
sensor until the indicators go out.
To avoid saving the settings
While the code is showing in the dis-
play (e. g.
:
) touch the
sensor
until the indicators go out.
Summary of Contents for KM 7678 FL
Page 80: ......
Page 81: ......
Page 82: ......
Page 84: ...M Nr 11 184 680 07 en GB KM 7678 FR KM 7678 FL KM 7697 FR KM 7697 FL KM 7878 FL KM 7897 FL ...
