Installing the appliance
79
Only for an appliance with a niche
height greater than 140 cm
For additional stability of the appliance
in the unit, push the rods supplied in
underneath the appliance between it
and the floor of the housing unit:
First secure the handle
to one of
the rods
.
Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as it
will go.
Important:
Keep the handle
somewhere safe in case you ever
need to fit the appliance into a new
housing unit.
Close the appliance door.
Fitting a furniture door
If the appliance is being built into a run
of units, the height of the furniture
door should be aligned with adjacent
kitchen units.
The furniture door must be mounted
plane and free of tension.
The following chapter describes the
installation of a furniture door with a
furniture front of at least 16-19 mm
thickness.
A gap of 8 mm is set at the factory
between the appliance door and the
fixing bracket. Double-check this gap
and adjust it if necessary.
Push the fitting aids
up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see
in diagram).